Here in Fort Worth we believe it will stay 100 degrees forever. And our fall temperatures don't change a huge amount. But when the old Blue 'Norther rolls in with its bone chilling 15 degree blast, are your sure your furnace is tuned and ready to perform? Are you sure it is safe, clean and efficient as it can possibly be? Well, now you can be!
Call today for your Fort Worth gas
furnace tune-up and save $20.00
Our environmental furnace rejuvenation is normally $129.00.
But if you schedule now you can save $20.00 - and
also quit overpaying the utility companies by
running an inefficient furnace. Let us
return your furnace to "factory fresh"
condition. And get your second
furnace tune-up at half price!
How do we know it is safe?
Our technicians are background checked, drug tested and
professionally trained for your protection. Their job is to
focus on your particular furnace and run it through its
paces while testing the temperatures, voltages,
flame, pilots, amperages and safety devices.
It takes time to do it right. They will enter your home
in Fort Worth with a clean uniform, identification badge
and floor savers on their work boots to protect your
flooring. And they will carry special meters and devices
that test your furnace from top to bottom. But we
don't stop there.
What we will do
A thorough inspection and furnace tune-up includes
the following:
-Measure incoming voltage
-Check for proper system ground
-Tighten all electrical fittings
-Test circuit board for proper operation
-Measure temperature difference
-Inspect flue for integrity
-Carbon Monoxide (CO) test
-Amp draw of high voltage circuits
-Amp draw of low voltage circuits
-Adjust thermostat anticipator (if applicable)
-Inspect pilot flame and adjust
-Test hot surface ignitor
-Inspect gas line for Code nipple
-Inspect for proper combustion air
-Test negative air pressure switch
- Inspect and test induced draft motor
-Test high limit switch for safety shut off
-Clean furnace vestibule and burners
-Adjust burners and crossover ignitors
-Clean blower motor, test and adjust speed
-Inspect and test main gas valve and adjust
-Clean and inspect thermocouple/flame sensor
-Operate furnace and observe for flue restrictions
-Operate furnace and observe for airflow restrictions
-Inspect heat exchanger for cracks, holes and hot spots
-Inform homeowner of discrepancies if any
Guaranteed work
If your furnace fails during this heating season after
our furnace tune-up and rejuvenation we will return
and repair it for free. Our guarantees are in
writing on the back of every invoice - so you can't lose!
We use the INSPECTOR,
This is an infrared camera inspection tool for a true inspection of the heat exchanger inside your furnace. This special device was designed for inspection of heat exchanger cracks for the US Navy. And we have been factory trained in the use of the Inspector. We check for cracks, holes and "hot spots" that can cause the deadly leakage
uses a built-in DVR recorder to document any failures. Then we give you a DVD as proof.
This protects you from fraud and technicians that are paid on straight commission only.
Your safety and comfort are our concern
That's why we use the latest technologies and training to insure your system is safe, clean
It is an A+ rating because we care about you.
Call today to schedule your furnace tune-up
Our friendly Customer Care Representatives are ready to take your call and schedule your
safety furnace tune-up. Be ready for the coming winter blast and save $20.00. With our
team of winning professionals, written guarantees and more efficient operation - not to mention comfort - you can't lose! Call today. 817-560-4300